PrusaSlicer
PrusaSlicer copied to clipboard
prusa3d
G-code generator for 3D printers (RepRap, Makerbot, Ultimaker etc.)
**Is your feature request related to a problem? Please describe.** There are some cases where on a model organic supports may be good in one section but the normal snug...
### Description of the bug  Attached image shows the problem. I used recommended settings to avoid the branches and avoid crossing permitters. For this print it did not cause...
### Description of the bug When using 0.08mm layer height on my 0.4mm nozzle profile organic supports works fine. This is with default extrusion of 0.4mm and support extrusion 0.36mm....
### Description of the bug Turned on supports and all around the perimeter of a small gear appeared small scribbles that end up doing nothing. ### Project file & How...
**Is your feature request related to a problem? Please describe.** I would like to slice and generate gcode from a model file using the command-line interface. **Describe the solution you'd...
Hello. It would be great to have the option: not to cross the perimeters only on the first layer. Superslicer has the option, avoid_crossing_not_first_layer. I prefer Prusaslicer, seeing this option...
**Is your feature request related to a problem? Please describe.** This is by no means a problem. Prusa Slicer is my primary slicer of choice. **Describe the solution you'd like**...
This is a suggestion for improved print quality. I first suggested this in a discussion about motion compensation in the firmware section. Alessandro Pantaleon from Prusa support suggested, that I...
### Description of the bug  When slicing this model at a 45deg angle (with some variablility +-5deg), the maximum height error is emitted despite the model being significantly less...
### Description of the bug On my first ever try with organic support it seemed like the part I tried to print on top of the branches was a bit...
