Michael Stegen
Michael Stegen
Ha! I'll see if i can order some pre-made modules with a Qualcomm chip. I found some from 8devices and chargebyte/intech.
Thanks for the reminder, just ordered some red/yellow beet-e modules to play with.
I received the modules (Red beet/ Yellow beet and Red beet carrier board), but had no time yet to look into it.
Great that you received your dev board. I think you can connect the AC_L and AC_N to L and N of the SmartEVSE. As the homeplug data is injected on...
Currently the webserver just shows a status page. It's not yet possible to read/write values directly using unique endpoints like /chargecurrent or /temperature The only two endpoints that currently work...
Hi, This is caused by the EVSE slowly increasing the charge current, and the EV usually waiting 10-40 seconds before actually drawing current. I think the easiest solution would be...
Hi, The mainsmeter options were developed by @bobosch with a specific use case in mind. If i remember correctly the Home+EVSE option measures everything except PV which is fed into...
Your settings for each controller look ok. The idea behind the current calculation is that only the -measured current- on the MAINS will determine what is available for a EV...
Did you set two different modbus addresses for each SDM630?
address 11 and 12 should be ok. The measured (Mains) currents for each phase should be visible on the LCD of the SmartEVSE. Also when the EV is not charging....