Michael Stegen
Michael Stegen
You could use the Sensorbox 1.5 code as a starting point, but i guess you have that atleast partly working, otherwise the SmartEVSE will show an error message on the...
``` for (x=0; x
You asked "How can i emulate the Current from the Software" This seems to be working.. I see 2A displayed on the LCD for each Phase. Also the CAL values...
When starting to change IsetBalanced will be set to the max current of the EV circuit. The 80A hard limit was added before the EV circuit option was available. I...
When you enter the setup menu, the software version should be visible on the LCD. The version is also shown when powering up the controller for two seconds.
Yes, two contactors to switch between 1/3 phase charging is a good idea. My main idea was it to use it when solar charging. You start slow with only one...
They are being manufactured now. ETA is February.
Using the lock output to drive a (solid state) relay, which in turn then can switch the relay on/off could work. But you still need a way to isolate the...
Hi, Getting the state of charge level from the car through the cable, is unfortunately not possible. So we have to rely on external service to provide the soc. This...
It could be that the car is cold, and that it tries to pre-heat the battery. On my model S i see something similar. When cold, it keeps switching between...