Lars Kasper

Dear Ruwan, If you open the function, you should be able to set a breakpoint (red dot) next to line 164. After that, rerun your script, and when it stops...

Hi, thank you for trying out PhysIO! The PhysIO Toolbox does not show up in the Toolbox Dropdown Menu of SPM. It can be found if you start the Batch...

Dear @ttsengataeuroling, Thank you for trying out PhysIO and searching here in the issue forum for an answer first. Could you tell me what the content of `spm12/toolbox` is on...

Dear Viktor, My apologies for the late reply, it must have slipped my attention during the end of the year crunch, and now I am on parental leave. Thank you...

Dear Viktor, I am not sure I understand the issue about the 3D EPI - is it about the sequence itself (for example, the trigger does not occur at the...

Dear Alexandre, Thank your for bubbling this up again - I don't think you are at fault, as far as I remember, this was never dealt with correctly to begin...

Dear @sev-ince, My apologies for the late reply - I am happy you are using PhysIO! Please see my answers below: > > 1)I am using acompcor regressors for denoising....

Dear Tasha, My apologies for the late reply. Solving the multiband timing input is unfortunately a well-known (and requested) missing feature in PhysIO, but there are some workarounds, see for...

Dear Matthew, Thank you for your positive feedback regarding PhysIO! I believe you can (and should) use the "long form" trace out of the box. It might take PhysIO a...

Dear Matthew, I agree with your choice for synchronization. Regarding using the `first` or `last` scan volume for synchronization, in your case (Siemens) it's fine to use either, as long...