TCIII

@thielepaul, Hopefully you are familiar with CMake to build opencv4.6 + GStreamer from source. I tried to build a wheel for opencv4.6 + GStreamer but was unsuccessful no matter what...

@thielepaul Tensorflow 2.9 and opencv 4.6 are fairly recent versions, though not the latest, and have been found to work well with the DC training. I doubt that armbian will...

@Ahrovan, Are you willing to spend two hours building and installing opencv4.6 + GStreamer? I run my Nano's 5 vdc power supply on a UPS so that powerline glitches and...

@Ahrovan, I am just a software/hardware tester who validated the DC tf_2_9 branch installation instructions so it will be up to DocGarbanzo as to the release of the Beta installation...

@Ahrovan, Could you please the document the "with small changes in install steps"? Did you install JP5.x on the Xavier NX? TCIII

@Ahrovan, > * just for test, donkey ui, don't work properly in JP502 @TCIII @DocGarbanzo Very strange as I have had Donkey UI working on my Xavier NX 8GB running...

@DocGarbanzo, `./Mambaforge-Linux-aarch64.sh` S/B: `bash ./Mambaforge-Linux-aarch64.sh` TCIII

@DocGarbanzo, I have a spare Xavier NX that is running an older version of DC that I can attempt to install JP502 and the DC tf_2_9 branch this weekend. TCIII

@Ahrovan, Are you using your Xavier NX for training or driving? I use mine for training only. Are you using a SSD with your Xavier NX? I am running a...

@Ahrovan, Are you booting JP from the SSD? If so, did you create a 6 GB swap file before or after moving JP from the microSD car to the SSD?...