Manta-M8P

Manta-M8P copied to clipboard

How do I use stealthchop mode with tmc2209? I uncommented the tmc2209 config section but when I try to do a homing, mainsail gives me this error: Unable to read...

theprintingpress

Homing failed due to printer shutdown

3

I'm getting "Homing failed due to printer shutdown." or "Unable to write tmc spi 'stepper_x' register GCONF" when trying to home custom Vorom 2.4. I've checked motor wiring and all...

fish1942

How do you change the steps from 8 to 16 using the 2209 For some reason my board and 2209 setup is 8 steps, is there a way to change...

Piccyman

Unable to flash Manta M4P

3

I am having difficulty flashing the MCU of the manta M4P. I have tried the following - compiling klipper myself and using SD card slot (full size SD card) -...

Gabriel121217

Dead USB Hub

6

# USB Hub dead ## Hardware: - BTT M8P - Raspberry Pi CM4 2GB ram, 32GB eMMC - Voron 2.4 printer ## Issue: * M8P's onboard USB hub has died...

timmit99

I am attempting to use a DWIN LCD (the one that came with my e3 v2) on a manta board, and cannot get it to boot. I am wanting to...

mtate-00

Manta M8P+CB1+TFT35 SPI display white screen on first power up

1

Manta M8P V1.0 board with CB1 and TFT35 SPI display on most first boot power ups results in a white screen with no boot, if I immediately shut it down...

Eclypse3D

When power is applied, the indicators of the 12, 5 and 3.3 volt stabilizers light up. The power indicator at the bottom blinks once and does not light up. Turning...

FiViSt82

Pin issue

1

I've prepped an OS image for my Manta M8P w/ CB1 (no eMMC), added the "generic-bigtreetech-manta-m8p-V2_0.cfg" config file, and i get this error on startup: 

dunbard0401

DSI and CSI not working at the same time

2

im using my M8P with a CM4 4gb ram and 8gb eMMC with a PITFT 2.0 with DSI and a cheap raspicam over CSI. If i connect the display alone...

Peviox