Snapmaker2-Controller
Snapmaker2-Controller copied to clipboard
Snapmaker
Snapmaker2-Controller is the firmware for Snapmaker 2.0 3-in-1 3D Printers.
Model: A350 with Dual Extruder Scenario: Want to be able to change filaments mid-print using M600 g-code at a specific layer to allow for printing with greater than 2 colors....
Just had to use the snapmaker emergency stop button while using the laser module. It shut down the stepper motors but the laser beam remained on and unfortunately damaged my...
For Laser and 3DP the controller should monitor serve load to avoid hard collisions and stop on overload. There is no need for laser to keep pushing in the objects...
I had 3DP calibrated and working. I switched to laser, Calibrated and worked with it. I switched back to 3DP to print something. The printout starts 5 cm above the...
I started my print without filament in the right nozzle. It detected there wasn’t any filament, but the temp screen only showed the left nozzle temp and the buttons never...
Using 350T SM 2.0 and 1.15.26 firmware. Attempting to load filament and purge end of filament, firmware will not allow it. Go to the control panel and select nozzle. Confirm...
If I start the machine with dual extruder head installed, but only one hotend in place, the printer says "Anormal hotend - print head powered off". If I then go...
If I start the X/Y calibration wizard from the touchscreen, I have the option to choose "Load filament". If I do so, I get to the nozzle control page and...
In 3D printing, the files are sorted by date, but in laser cutting, they are sorted by file name. I would like the laser cutting to also be sorted by...
If the GCode for a laser Job uses G91 (relative positioning), and that Job is paused via Touchscreen, after resuming the Job all laser lines are happening at the origin....