Snapmaker2-Controller
Snapmaker2-Controller copied to clipboard
Snapmaker
Snapmaker2-Controller is the firmware for Snapmaker 2.0 3-in-1 3D Printers.
I run a simple CNC job and wanted to pause work for fixing clamps. After pressing Pause on touch screen the head went into up position. When I pressed resume,...
Hi, I'm trying to fetch my Snapmaker 2 status from a very simple javascript app, but failed because there is no CORS header allowing webpage to request and consume json...
1. Feature: update version to v4.7.0. 2. Feature: supports 2W Red laser. 3. Improvement: Check for the presence of any flame sensor(cross-light,camera).
Some people bought the new 20/40W laser including the air assist pump while having also the 10W laser. However, when the 10W laser is connected the pump does not work....
Damage to the linear module due to table contact caused by misoperation during Snapmaker 2.0 touch panel operation has been observed. With the introduction of the bracing kit, when the...
Often, there are cases where the module collides with the bed during movement along the Z axes. I would like the ability to set the boundary points of the movement...
I submitted this on the Luban side, but I think it is more meant for firmware. Ever since the change to using inline mode the 10W laser seems to be...
There is no need to do this. When I finish a CNC job, sometimes I want to just manually jog the head over to a new area to begin a...
