MK4duo

MK4duo copied to clipboard

CAN'T BUILD SCARA MECHANISM

2

1. Firmware version: v4.4.0 2. Setting: #define MECHANISM MECH_MORGAN_SCARA 3. error: 'float_limit_t' does not name a type float_limit_t base_pos[XYZ] can you help me check it? thanks

annhan

Hi, can I change the stepper pulse / rate / delay settings for each stepper motor driver?

Flynuga

Nextion with arduino atm2560

2

Hi everyone!, Hi admin pro. I can't connecting Nextion with atm2560 (Ramps 1,4) I use uart1(18,19) or uart 2(13,14) but im fail I think code config fix Have you help...

lkevin271097

I've been trying to calibrate my Delta Printer with Probe type set to Manual, and Calibration type 2. The hotend goes down till the set height after which I am...

lohiaprateek

Hi pro! I want to time display, but i can't find line code set time,  

lkevin271097

Hello all, I'm experiencing deviations or step losses while printing. In this image you can see the deviations that i'm talking about. After having printed this same part lot of...

PabloRobotics

Enstops ignored while homing

8

On my delta setup, the enstops are being ignored while homing (G28). When using a G1 command to move the carriages all the way to the top the enstops do...

DvDriel

Ultratronics Pro Can't read SD while LCD enabled

3

### Issue description SD Card reader (on board or via LCD) works fine providing Reprapworld Graphical LCD (or Reprapdiscout full graphic LCD) is NOT enabled. As soon as I enable...

c3D-Dan

I had issue with endstops y axis and found bug. in file Configuration_pins.h // ENDSTOP pins #define X_MIN_PIN ORIG_X_MIN_PIN #define X_MAX_PIN ORIG_X_MAX_PIN #define Y_MIN_PIN ORIG_Y_MIN_PIN #define Y_MAX_PIN ORIG_X_MAX_PIN

AleyRobotics

arduino does not recognize dfu mode

1

does anyone know how to solve? Arduino: 1.8.12 (Mac OS X), Placa:"3D printer boards, RUMBA32, STM32CubeProgrammer (DFU), Enabled (generic 'Serial'), CDC (no generic 'Serial'), Low/Full Speed, Smallest (-Os default), Newlib...

Briangsouza