MK4duo
MK4duo copied to clipboard
MKFirmware
MK4duo Firmware Printers 3D for Arduino and Arduino due
Hi use 4.3.3 with TMC2130Stepper @Beherith library for soft SPI And I can not set a motor current. In config i have #define X_CURRENT 800 #define Y_CURRENT 800 but in...
hi! how i can disable coordinate output? like this X:91.07 Y:126.12 Z:8.500 E:0.0000 X:94.00 Y:110.89 Z:8.700 E:0.0000 X:99.00 Y:116.18 Z:8.700 E:0.0000 X:104.00 Y:118.50 Z:8.700 E:0.0000 X:91.00 Y:125.55 Z:8.700 E:0.0000 thank...
Hello. Recently updated firmware from 4.3.29_dev version to actual 4.3.3 and found some bugs. If print pause is requested from LCD menu with subsequent print stop action requesting, then no...
### Issue description Installed BLTouch, I decided to configure Auto Bed Leveling. Configured according to the instructions. **G28** runs well, with no errors. **G29** goes to the desired coordinates, takes...
### Issue description I have a Migbot Prusa i3 3D printer. My Z endstop is setup in such a way that when extruder is completely homed in all 3 axes,...
the commands to warm the hotend, bed and move, works. but the sd card I can not print in fw 4.3.6 only in fw 4.3.5 everything works normal
LCD reprap full graphics 128x64 don't starts after power up and I have to press reset. after that it starts. I set #define DOGM_SPI_DELAY_US 12 maybe its too much or...
### Issue description 1. Insert sd card 2. Connect via usb by Repetier-host 3. After reading sd card file list, printer hang If I remove sd card, then connect via...
I noticed that the Auto Extruder Fans don't always turn on. I have 2 extruders which share the same Auto Fan pin.
If i set the controller fan to auto, the fan is started when the motor are running. But when the hotend or the heated bed are switched on the controller...
Metadata
Owner
Metadata
MK4duo Firmware Printers 3D for Arduino and Arduino due