Dominik

Thanks, from the known fields the following changed: Temperature set to 10 (5°C, was 22°C) Fan speed is set to 70 (level 5, was auto) Is the fan speed on...

Played around with the target temperature on my AC and it goes down as low as 0°C, not sure if it will actually do it but it will accept the...

Yes, from what I have seen so far it seems to just switch to HEAT mode, locks the temperature range to 8-15 or 8-10 and the fan speed is locked...

@donnib It's no problem for me to add a switch that enables "Summer house mode" or "Freeze protection". It's just a matter of knowing which parameters to set for it....

@agrauballe There are 2 different protocols. DNSK-P11 uses ack packets and different commands for each action and needs a queue. CZ-TACG1 has no ack packets and only sends a single...

Can you take a picture of the connector that connects the CZ-TAW1 to your AC?

ESPHome already supports state_class and device_class, you can just add them to any sensor in your config. ``` current_power_consumption: name: Panasonic AC Power Consumption unit_of_measurement: W accuracy_decimals: 0 device_class: "power"...

Yep, that's it. You probably can replace the bottom module with an ESP. Make sure to measure voltages on the connector first to be sure. There's a pinout in the...

@vjmaz Take a look at the readme for the DNSK-P11: https://github.com/DomiStyle/esphome-panasonic-ac/blob/master/README.DNSKP11.md There's a pinout there for the 8 pin connector.

@dkanada Seems to be the same issue, yes.