Dominik

Can you take a picture?

Interesting, don't think I have ever seen that connector. My units don't have that connector. You probably will have to measure the voltages and use a logic analyzer to check...

Looking at your log the AC responds with a valid packet but one that is not known to me: `5A.00.00.06.00.00.A0.5A.01.00.09.00.00.9C`. After that the data is not parseable anymore (starting with...

> I'm looking at this one here: https://www.phoenix-tech.co.nz/products/saleae-logic-analyser?variant=12429818036272 Ideally it supports PulseView so I can open it easily. There's a list of supported devices here: https://sigrok.org/wiki/Supported_hardware Any with 2 channels...

> Looks like it needs to be plugged into a device for power and to do the reading Yes, you will have to have a laptop connected with PulseView running...

Pretty cool! This issue is probably also interesting for you if you didn't see it yet: https://github.com/DomiStyle/esphome-panasonic-ac/issues/12

> If it'd be better for this to be combined into that issue please let me know and i'll close this one and post in there! Thanks again for the...

It is currently not supported. In order to add support for it an ESP connected to CN-CNT or CN-WLAN is necessary in order to log the incoming packets.

@agrauballe Thanks. Currently the temperature is locked from 16 to 30°C so a separate switch to enable the mode will need to be added I assume. Will be interesting to...

@Sundius You can turn on verbose logging in ESPHome and post your logs in different modes. That should show what is being set by the Comfort Cloud app. You will...