Dominik

@ss4344 The integration currently does not save the previous state or compare to it when a new one arrives. The polling interval is 5s for the CZ-TACG1 and 30s for...

That's pretty cool. Maybe you guys can do a combo one with both connectors onboard? I would order a few of those too. Could probably add a DIP switch as...

Are the files for the PCB open source? Maybe it can be done with an adapter cable or 2 variants.

I think I can see the CN-CNT connector above your wifi module so you should be able to test just fine. You can even connect both at the same time.

> Can you explain te difference? Why has my unit have both options and are there different panasonic units that only have CN-CNT? CN-CNT is the older connector that (almost)...

> is it correct that you soldered wires to the back of the DNSK-P11 in which you can use both the official as the esp32 for sending commands? Or are...

Looking forward to the article. I would take 4 if they're not too expensive.

Yes, that's a DNSK-P11 and you can replace it with an ESP.

I believe the on_boot section only works in the esphome context. But the GPIO switch should work: ``` logger: level: DEBUG hardware_uart: UART1 uart: tx_pin: GPIO15 rx_pin: GPIO13 baud_rate: 9600...

Just like with the power usage stats I'm currently not interested in reverse engineering any automation related features since I use Home Assistant to control my AC. Including turning them...