teachingtechYT.github.io
teachingtechYT.github.io copied to clipboard
teachingtechYT
After running a hotend PID autotune then saving to the EEPROM with M500 and a heated PID autotune then M500 it didn't save the PID values when I used M503...
In the `calibration.html` file, line 1199 reads: `You can enter M203 into a terminal and the maximum set feedrates will be reported.` However, sending M203 does not echo anything. Later...
I recently calibrated my E-steps and might've found an easier way of doing it. 1) Heat up the hot-end to allow the extruder to function. 2) Remove any filament that...
https://teachingtechyt.github.io/calibration.html#speed As in title. Gcode Generate button only uses the Perimeter feedrate for the first layer (ie 40). This value then used for all segments A-E regardless of what user...
The menu in the examples for settings are not compatible with the current version. some confusion might arise ? Yours 
Whenever I load the file into Octoprint I get an error telling me slicer setting were not found. GCode generate on other tabs seem to be working fine. Been using...
Hi, when I download gcode for calibration, printer set temp to 150°C instead 200°C. When i set it to 205 - printer 155°C https://teachingtechyt.github.io/calibration.html#accel
have followed the guide this far, and this is what i have been looking for, everything is well explained, BUT i have run into some troubles understanding WHAT and WHERE...
i have an ender 3 s1 pro, and have some custom X and Y offsets for my ABL probe, all that is fine, but where the issue appears is in...
I have an interesting speed upgrade that may be of interest for further discovery? have been seriously upgrading my Ender 3 Pro… Systematically, I have been watching the effects of...
