diyBMSv4
diyBMSv4 copied to clipboard
stuartpittaway
Version 4 of the diyBMS
When designing and building boxes for the 4.3 controller, the rx/tx connectors end too far inside the box. By putting a second set of holes near the edge, one could...
Hi Stuart, Would it be plausible/possible for the cell module to not use any onboard cell balancing resistors/thermistor combo, but instead have the option to take that signal straight to...
Hi, i might have flashed the wrong version on my cell modules (v430 instead of v421). When I try to reflash, the green LED on the module flashes once and...
Hi, What about preparing active balancer board compatible with v4.90 version? I thought about using eta3000 driver so inductive type. I could prepare schematic and layout if I will change...
Add to ```config.kibot.yaml``` for all sub-projects to support PCBWAY paste requirements. ``` - layer: F.Paste suffix: GTP - layer: B.Paste suffix: GBP ```
I have a li-ion battery from an electric car (car floor). Currently, this battery works with a Chinese BMS and a HYD 20 KTL-3PH inverter. It works well but lacks...
When i open the ControllerCircuit Schematic in KiCad i get a message that `ControllerCircuit-cache.lib` is missing. This isn´t a problem as almost all libs are there, so all symbols are...
all-in-one consider using MAX6107EUR+T for 4.5V reference https://datasheet.lcsc.com/lcsc/2202211530_Analog-Devices-Inc--Maxim-Integrated-MAX6107EUR-T_C2976399.pdf
This issue is purely documentation for connection of 16S monitoring boards and the DIYBMS v4.X controller. Cabling is similar to the single cell monitoring modules. **DO NOT CONNECT TX TO...
The Range data and the Current data would be very useful for monitoring through Influx - grafana
