hw_microRusEfi

hw_microRusEfi copied to clipboard


rusefillc

JLC orientation drama

1

We need a solution for orientation drama. Each CPL file has it's own orientation differently and each order is the same or similar stress of Q and A from JLC...

rusefi

[0.5.2] D13 orientation and MANY other :(

1

Similar to #183 but about D13 and many others Updated comparison file at https://github.com/rusefi/hw_microRusEfi/tree/master/gerbers/R0.5.2

rusefillc

IS25WP256D-RMLE is a 1.8V part

3

We are 3.3 so we need IS25LP256D-RMLE L, not W

rusefi

[test fixture] wiring usability

1

pigtail has many short wires so from mechanical side of things at the moment it's tempting to mount it on the back side of the PCB - this case all...

rusefi

test fixture: power some low-side LEDs from sensor 5v output

2

don't power all low-side from +12v power some of them from each of the 5v sensor supply outputs from MRE that way we can test two birds with one stone

rusefi

test board: wire buttons to the analog inputs

4

@mck1117 says "one idea I had for a test board I had: wire buttons to the analog inputs, and LEDs to outputs. Write firmware that just reads inputs and writes...

rusefi

test fixture: buttons should have through-hole option or same as MRE

6

at the moment text fixture uses some unique button footprint let's share footprint with MRE or better allow through-hole option. I suspect that my through-hole push buttons are 0.2x0.2 inch...

rusefi

test fixture: LEDs for all GPIO

1

we need traces/vias/LEDs for all GPIO outputs J9 J10 etc

rusefi

for next revision let's add external USB connector traces to a USB connector and have vias for all SWD pins so that MRE could be programmed via test fixture

rusefi