pascallanger

I can't stop... Phase 1: read status register=0x0E->nothing, write status register 0x2E->clear data sent=>it is already at 0 and anyway nothing has been sent yet. So Phase 1 does nothing......

This is the manual, correct? http://www.kyosho.com/jpn/support/instructionmanual/minium/pdf/10655_Edge_540_m.pdf Bind procedure is described on page 8.

Ok the bind is on the same page 8 with the same method. @steff-wink Can you follow exactly the process and do a dump? Make sure to record before the...

From the doc, you power on the plane and wait long enough so that it goes in bind mode -> look at the LED on the RX it should show...

I have all the information needed to write the code. Check these 2 posts for all the details: https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/issues/658#issuecomment-1179436461 and https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/issues/658#issuecomment-1179444149 .

Are you able to compile the code by yourself? If yes the protocol Kyosho2/KT-17 is available on master using @steff-wink ID for now. If not then you'll have to wait...

Hi Ben, I was going to contact you exactly for this😁 i haven't used your latest version. I'm thinking the link to the board is in the thread you mentioned....

Let me ask a stupid question: have you pressed the bind button on the GUI while the plane was in bind mode?

Ok let me check.

Let's try first to bind your CX10 with an old version of the FW like: https://github.com/pascallanger/DIY-Multiprotocol-TX-Module/releases/tag/v1.3.1.78