dji-firmware-tools
dji-firmware-tools copied to clipboard
o-gs
Tools for handling firmwares of DJI products, with focus on quadcopters.
My Mavic Mini uses him and can't work normally C:\Users\Martian\Downloads\dji-firmware-tools-master>py comm_og_service_tool.py -vv com6 MMini GimbalCalib JointCoarse Opened com6 at 9600 Info: The Gimbal will move through its boundary positions, then...
Hi all! My name is patricio, i have 1 Board for phantom 4 standard with problem V0.00.0000 in dji assistant 2, (the live transmission don't working) , i try update...
Hey folks, just tried to use this tool with the Mavic Air 2 following gimbal/camera replacement but upon running each of the two commands, I get this error: - Unrecognised...
Hello guys, I dont find comport of my mavic mini. i just have this: USBSTOR\DISK&VEN_DJI&PROD_WM160&REV_1000\0001&0 no com port. so i can't do this command: python comm_og_service_tool.py com1 MMINI GimbalCalib JointCoarse...
when use the og tool to list param on Mavic Air ,I got a lot "Response on parameter 471 indicates end of list despite larger size reported" Message, I think...
Hi, On my Mavic pro I've got connection issues during a calibration, there is no response on all sent packets. On all other drones it is working (tried Mavic air,...
In the Phantom 3 series UAVs, does the flight controller perform other operations on the GPS module besides increasing the baud rate of the GPS module from 9600 to 115200...
Hi All, Does anyone have any experience bringing RC's back from the dead? My RC died after a botched firmware update. All that works now is the backlight. This is...
Does anybody have an idea how to calibrate newly replaced infrared sensors (Rear vision board, Lower vision Board) and get rid of the infrared calibration errors? Using Dji Assistant or...
