dji-firmware-tools
dji-firmware-tools copied to clipboard
o-gs
Tools for handling firmwares of DJI products, with focus on quadcopters.
Hello everyone ! I found this awesome repository with every tools I need to make my custom firmware. It's a very complete solution, congrats to every developers behind it !...
RC Firmware must be changeable too. Some limitations was added with RC Firmwares 1.6 and newer. Output Power is reduced from 25mW to 10mW in CE Mode. And It should...
C:\DJI>py comm_og_service_tool.py com3 -vv WM240 GimbalCalib JointCoarse Opened com3 at 9600 Info: The Gimbal will move through its boundary positions, then it will fine-tune its central position. It will take...
Can you explain to me in detail the procedure of connecting Ambarella chip to the usb port on the computer.
anything you can think of. im staring at a fresh extraction of 1.6 looking for options
i got a phantom 3 pro. from what i understand they don't use a wificard according to hostapd.conf it is a nl8011 chipset card. i would like to enable a...
Please note I have tried everything already so bear with me, I am sorry if this is a long post. The camera and gimbal on my Phantom SE are working...
Good I tried to install the Firmware m0100 by USB UART, without success: using the methods of: https://github.com/o-gs/dji-firmware-tools/wiki/Flashing-firmware-via-SD-card#by-firmware-module-in-camera https://github.com/o-gs/dji-firmware-tools/wiki/Firmware-m0100 Extracting: P3X_FW_V01.11.0020_m0100.bin and renaming it to PFC300XFw3.bin I tried it with...
 Hi there! Just tried to perform the calibration of the Linear Hall sensor but it failed. Do you have any ideas what should i check when it comes to...
Hi, we have several Phantom 3 Advanced drones which were upgraded to Pro by changing gimbals or camera control boards and flashing Pro firmware. After a several hours flashing of...
