nfp0
nfp0
I can confirm this only happens on multi-monitor setups. When I have only one monitor enabled, it works fine.
@Vamp898 You tested it in Weston and it was failing there. If it fails on Gnome, KDE and Weston, it's likely to be something on the RetroArch side. LabWC might...
I have the same or very similar problem on a clean new RetroArch config. I am running KDE Wayland on Arch and I have 2 screens. In fullscreen mode, if...
@serhii-nakon Fantastic! Thank you for sharing the captures and the instructions. 😃 I really hope someone from the kernel driver takes a look at those. @LuanVSO Thank you for the...
@LZZZZ I am not sure, but I think the card needs to be put in some "surround mode" by the driver. So yes, it also ends up being a lack...
@serhii-nakon The channel interference sounds like some hardware issue, but I haven't tested surround on my board. > I even think that here no hardware amplifier for microphone and on...
@serhii-nakon Yes, there will be too much data if you capture everything, but if you filter by outgoing packets only, the incoming packets should not show up. Try filtering by...
@patlefort Can you perhaps find a way to enable the Gain setting with that same method? @serhii-nakon Any luck filtering by outgoing packets only.
I have a very similar issue only with HDR on, but to me it happens some 10 or 20 seconds right after I start RetroArch, just navigating the playlists games...
I have noticed that it only freezes when I'm navigating menus with game covers. For example, when navigating up and down on a playlist with available covers on the XMB...