Mark
Mark
I don't think of that. the install of BDsensor is only copy the source code file BDsensor.py and BD_sensor.c into the klipper folder and let it can be compiled into...
seems that the nozzle is still touch the bed after it move up 0.3mm. the sensor will use the first point as the zero position so that will cause problem.you...
if it still too close to the bed, then use the z_adjust that is used for replaceing the z_offset
> Can i still do babystepping over the web ui or klipperscreen? It can only be settled by manual now, but you can use the web ui to do babystepping...
> With adjusting Z Offset values back and forth in printer.cfg i got one good print with a nice first layer but the next one wirhout changing anything and same...
would you tell me the hardware version? or the version after the M102 S-1
I am sorry for that bad experience and thank you for feedback this problem and support. the hardest thing for us is that we still do not know the actual...
> 4. I made calibration with 0.1 from the bed and the numbers were good, but it's still scary to home the printer. you can try to increase the `position_endstop:...
> I have the same problem, my version is V1.1 pandapi3d.com > > What i found out of my observations: > > 1. You should calibrate only when hot (bed...
recommend the cycle time is 10ms.