Mark
Mark
the probe_accuracy is used for proxmity probe sensor that will move the z axis up and down then check the accuacy of the probe sensor, so the command of probe_accuracy...
did it report communication timeout during PROBE command?
> It errors before it even has the chance to start moving down to the probing position. > > Its not moving at all, I even increased the TRSYNC_TIMEOUT, no...
I am also testing and debuging the delta printer with my stm32 board + raspberrypi, it just works, but not easy to calibrate.
>  > > I've had success running M102 S-6 calibration, DELTA_CALIBRATE and BED_MESH_CALIBRATE and then printing. But this is all still with TRSYNC_TIMEOUT at 0.040. looks nice. about the...
What's the homing speed of Z axis, how about slow down more the homing speed of Z axis?
also set the `horizontal_move_z` in the `bed_mesh `section form 2 to 1 , because the actual distance it can measure is 2.2mm from your data from 230 to 980.
Someone fixed it by re-install and re-flash the mcu, you can try that. also try to slow down the home speed from 8 to 4 in section stepper_z
> Homing, z_tilt , bed mesh in general and KAMP are working now but i get very inconsistent first layer when printing with pla (60°C bed). First time the nozzle...
> When (and why?) exactly do i have to calibrate again? For example if the motor is unlocked before calibration the zero position maybe changed while doing calibration, because of...