Mark

> Another question, I figure out main problem when I Install the pluggin. The Klipper git repo returns to "Dirty". When I recover it. It removes related files. > >...

right > so does this mean we can do a probe z offset like we used to do with a BLTouch? this would save me so many headaches I'm having...

Normally just update it via Update Manager and restart the klipper, no need to compile and flash the mcu unless there is a version or protocol error reported by the...

> One more question: is there a way to set different speed for collision calibrate? One that is different from homing speed. Seems the only way is to edit the...

> While calibrating the sensor, it homes first. Should it retract before homing? When I set the nozzle on the bed, then M102 S-6, it homes X and Y but...

Hello, all the endstop pins for MKS board can not be used for bdsensor, for example the P1.25 is the X+ that is connected to a capacitor that can filter...

the data error 1024 means there is a connection problem, you can check the connection,pin name,choose the pins in the EXP1 connector for the BDsensor. > Hi Mark I'm also...

there are capacitors in the z+- on the skipper board,so I think this modified board is also the same. are there any other pins on the modified MKS THR board?...

> If I add a raspberry pi Pico and used the gpio on that would it work? > > Or last resort I could desolder the cap. we have tested...

> Just updated the MCU with the instructions here https://github.com/markniu/Bed_Distance_sensor/wiki/Flash-BDsensor(V1.1)-firmware, and now I'm getting the same error message. > > I also can not get any info from the sensor...