mark9064

Sounds promising! Fingers crossed...

After #2328 it now works all the time :) thanks for writing up this feature nonetheless The refactoring you've done still looks good though, if you would like to open...

Doesn't sound good :( Just to confirm, this battery drain started without any changes to the software on your watch, and still happens with base 1.15 If that's the case,...

The battery is a bare cell wired straight to the main board. The battery percentage is computed by the microcontroller measuring the voltage and then guessing how much energy is...

Even with AOD on it should last for about 48h continuously, so there's definitely something strange here :( Could you try installing 1.14 (or whatever you were using before) again...

Interesting, thanks for the update. If you upgrade to 1.15 keeping the connect on connection option off, is the battery life the same or worse? I'm trying to figure out...

Day to day battery life completely depends on how much you use it, whether HR is on, screen brightness, AOD etc. If you put the pinetime into sleep notification mode...

Ah yeah, don't read into the percentage too much - there's no fuel gauge and instead battery percentage is estimated from the voltage. So when the battery is under load...

The sampling rate of sensor can be changed, but it is not useful as increasing it only gives more information on higher frequency components in the PPG signal (see nyquist...

Ah right, sorry I misread you there The current implementation assumes if the screen is on the user is actively interfacing with the watch and so the heart rate should...