k3ng_rotator_controller
k3ng_rotator_controller copied to clipboard
K3NG Arduino Amateur Radio Rotator Controller
It seems that the serial monitor on the Arduino Nano Every is not working. I can't get access through Putty at all. Do I need to set something up or...
Hello, I configured my rotator with latest code and can use them with serial commands. When connecting to PSTrotator via ethernet it only turns right not left. I than fund...
I cannot understand how to perform the calibration using the parameters: #define AZIMUTH_CALIBRATION_FROM_ARRAY {180,630} #define AZIMUTH_CALIBRATION_TO_ARRAY {180,630} I need these parameters because my rotor has no linear variation, so I...
Hi have been struggling to get the position signal working with PST rotator. I have the basic control working so I can activate the rotation both ways im just using...
How do I make code fit on a nano with remoteqth kit?
Replace the current master/slave terminology with local and remote units. Implement all of the current master/slave commands as backslash commands and add new ones so that the remote unit can...
Hi , I decided to write this message because my previous attempts to configure and get help at https://groups.io/g/radioartisan have not worked. Below is my message from the discussion group:...
Hi, I don't know if there is any mode of operation that can work with my rotor. My rotor is very simple, it is a tagra 50, very old. This...
Hi my friend good work.. i try to use this project with arduino Uno .. but the memory is 101% please tell me who is the last version compatible whit...
Hello! I have a problem using the controller with Ham Radio Deluxe. First, after plugging the USB from the controller into the computer the rotor turns CCW until it reaches...