k3ng_rotator_controller

k3ng_rotator_controller copied to clipboard

HI K3NG I have some problems： 1. I am using LSM303, the elevation angle is around the X-axis, and the azimuth is in the X direction (if it is in...

ba5dx

Shows two lines only with the word "Azimuth º"

2

Hello everyone. I am using a MEGA 2560, incremental encoder CWZ6C Omron, tinyGPS Neo6M and 4x20 display ... it occurs that on the screen appear two lines written "Azimuth º"...

DirceuPY5DK

I am using an OLED 20x4 display successfuly. The display has no backlight and is too bright for night if no manual switch changes are being made. I loaded the...

Duane1951

I just realise, that some tracking software using comma to separate tenth of degrees in EASYCOM protocol. But K3NG rotator use a dot. Is it possible to change it somewhere...

maxmiztejm

Hello K3NG , I am using this type of OLED 👍 http://cdn-reichelt.de/documents/datenblatt/A400/DS_OLED_EA.pdf But sometimes line 1 and 2 are swapped together. And, when I update the arduino mega program, OLED...

ON8GE

What is the recommended arduino for this project it needs to run 2X TB6600 drivers going to 2X nema 17 steppers. I have a NANO but cant find the info...

nay27uk

OpenLCd and KS108 graphic LCD support

7

I tried to use KS08 graphic LCD with openLCD library... I added some features, now it works as it was with 2 line lcd.. But I will ad graphics capabilities,...

barisdinc

Graphics LCD Interface

1

Hi. I'm building a controller based around this code with a 192x64 KS0108 Graphics LCD and the openGLCD library. There doesn't seem to be any support for graphics LCDs? Given...

m1geo

Servo as Motor

1

Cant find anywhere to email you I need to know if I can use a servo as the motor. Thanks de 2E0LIG

nay27uk

Head problem on 16x2 LCD display

13

Hello K3NG! I trying make an your controller with 16x2 Display. The head is shown in this way: Azimuth XXX.X zimuth XXX.X The XXX.X are same in both rows. AZ/EL...

maxmiztejm