bdring

Agreed about the nearly full thing. Make sure there is more than enough room.

Rerun, install-fs.bat. I once got a "stuck" corrupted file that would not behave. Install-fs fixed it. Cleans out that partition.

- You will need to provide an update to the [wiki page](https://github.com/bdring/FluidNC/wiki/Fluid-Spindle-Setup). You can attach a file(s) in a reply. - You need to provide author information per the [pull...

Would it be better to add a poles parameter to the config file, so the firmware and speed_map can use real RPM?

Would M3S10000 be referring to ERPM in your case? That seems like a bad idea, especially for use with CAM software that uses real RPM.

Poles is similar to flutes on a bit. You tell the CAM software about the flutes and it then can work in RPM.

OK, I guess the rough analogy is lost on you, but we agree on the required changes to the code.

I think there is a way to avoid that, but it will require some changes to the firmware. I'll look into that over the weekend.

Fixed I updated the firmware. The devt branch has the changes. Firmware changes are tested there before moving to the master branch. The midTbot only homes the X and Y...

I'll double check the master branch when I get home tomorrow.