Grégoire Saunier

Open Source License

3

Hi Misfittech team, congrats for your very nice work. I was looking at your GitHub and saw this mention about the firmware license: > The firmware is licensed as GPL...

Z rods are not parallel nor perpendicular to XY

9

I discovered that Z rods are not parallel nor perpendicular to XY due to a misalignment of rod hole in z-axis-bottom and z-axis-top. In z-axis-bottom you translate the cylinder by...

Rounded nut hole for MK2.5 heatbed cover

1

On this picture :  The bottom-right hole as a rounded pocket hole for the nut. On MK3 design this one as a polygon hole. Fix for the file...

MK2.5 RAMBo base extruder cables hole is too tight

1

Hole for extruder cables is too tight on both RAMBo base and cable clip. This might also damaged the extruder's cables. Current hole radius is 5.5mm (with cable grips at...

Lots of people reported that the version 0.2 have melted PETG, this version should be removed from the repository. This might happen when there is a mechanical damage (like a...