Grégoire Saunier

It is not possible to extend GPLv3 to non-commercial uses, you have to use another license for that. Section 7 of https://www.gnu.org/licenses/gpl-3.0.en.html _All other non-permissive additional terms are considered “further...

Hey may I ask you to add a picture to show where to add the t-nuts? I am afraid people will get confused.

Hi, just to be sure I understand, are you going to use a longer print bed as well?

200mm longer print bed sounds excessive for bed sliding printers. Definitely 8mm smooth rids will have too much flex. It is hard to evaluate how stiff the 10mm should be...

Thank you very much

@akukan there is a risk that, during maintenance, someone shortcut + and - of the heated bed with the wrench. Maybe you can keep your previous solution and add a...

:satisfied: you know how that goes, we all went there I think... There is a safer way so why taking the risk?

I have also observed another problem with the x-end-idler :  In this image, the space for the screw head is bigger than the space for the nut. This means,...

Thank you for your answer. Will this be solved when first MK3 will be shipped? Best

Hello Serge, Your english is good to me, but my english is poor as well :-D Thanks to have take the time to check this problem. I did the assembly...