Jeff Geerling

Recompiling on 5.10.y with `Device Drivers > Network device support > Ethernet driver support > Realtek 8169/8168/8101/8125 ethernet support` as in #40.

Nice! ``` 3: eth1: mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000 link/ether 00:13:3b:b0:30:9c brd ff:ff:ff:ff:ff:ff 4: eth2: mtu 1500 qdisc pfifo_fast state DOWN group default qlen 1000...

Next up, benchmarking. After that, figuring out OpenWRT.

They all have IPs! ``` $ ip address 1: lo: mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft...

I edited `dhcpcd.conf` with `sudo nano /etc/dhcpcd.conf` and added: ``` interface eth1 static ip_address=192.168.0.10/24 static ip6_address=fd51:42f8:caae:d92e::ff/64 static routers=10.0.100.1 static domain_name_servers=10.0.100.1 ``` Then on my Mac, I added a _second_ interface...

So benchmarking is... fun. I can't find a good way to get two separate interfaces on the Pi routing traffic to one network card on my Mac, so I now...

On my Mac, in Terminal: ``` iperf3 -s --bind 10.0.100.144 ``` On the Raspberry Pi, in two separate SSH sessions: ``` # First make sure the internal network interface is...

Jumbo frames enabled between Mac and Pi (but on Windows I got wildly inconsistent results with Jumbo Frame in the advanced settings set to 9014 or any higher, so I...

This setup is horrifically annoying as I now have a spiderweb of cables through my office (I've only tripped on them once), so I don't think I'll keep it set...

I couldn't leave well-enough alone. I downloaded the [Windows WinOF Driver](https://www.mellanox.com/products/adapter-software/ethernet/windows/winof-2)—which _states_ it works with ConnectX-3, but in fact _does also_ work with ConnectX-2—for Windows 10 64-bit, and finally got...