Flashforge-for-Cura

Flashforge-for-Cura copied to clipboard

Cura 5.6 Creator Pro 2016_No preheating and wrong zero

3

Hi eugr, at first thank you for your work! Like described above my CreatorPro didnt start any preheating (bed and nozzle) and immediately start "printing" on the default printhead position...

jseifried

Creator Pro Does not show up

5

I copied the files into the folders, but Creator Pro still doesn't show up in the configurations.

noamtsvi

Cura 5.6

1

File Path: C:\Program Files\UltiMaker Cura 5.6.0 There is no **resources** to copy the files into.

DeepGeoTech

Creator 4

1

Will this support creator 4 printer ? Will the start and End G code be same for the creator 4 printer as well ? Thanks in advance !

kasunbhathiya

Starting with Cura 5.6 (5.5 works) - invalid GCode will be generated unless the attached changes are made. For example, setting bed temperature: Old Config + Cura 5.5: `M140 S120.0...

alexbdv

Monoprice Dual (Creator X clone) - Always prints with the Right Extruder

9

Cura 5.3 I am using this with my Monoprice Dual (Creator X clone) printer and it works great as long as I am printing from the right extruder. The only...

bthahn

Tool change necessary in Cura?

1

First, a big thanks for making the FFCP usable with Cura! In my prints with dual extrusion and one head printing support material, when switching between active head for each...

svarteld

Gcode for Octoprint

2

Request: Enable gcode generation that works with Octoprint. Using gcode generated from the "Dreamer NX" printer definition in CURA 4.9, I can load the gcode to Octoprint and it prints...

PeterJBurke

Print bed too small?

1

The default setting of "machine_width": { "default_value": 227 } in resources/definitions/creator_pro.def.json ; although accurate, has the side effect of the printer refusing to print on the last 1cm of the...

maathieu

Both extruders heat up even though only one is enabled

1

I have my printer set up with ABS on one side and PETG on the other. FlashForge Creator Pro 2016 Cura 5.0 When I go to print using the left...

dcacklam