Anthony Doud

Sure, I'm available to test if you like. Just tried a quick compile for S3 from master on an existing large project ([SmartSpin2k](https://github.com/doudar/SmartSpin2k)). Relevant platformio.ini: `platform = https://github.com/tasmota/platform-espressif32/archive/refs/heads/IDF44/ESP32-S3.zip` `board =...

Thanks for this! I was having similar issues (aborted print & on the next try, the printer started running the extruder full speed ahead which back flowed and plugged my...

I believe hardware interrupts are the preferred method for wakeups actually. I'd say if no clients or servers are connected and no shifter has been pressed for 30 minutes, hibernate....

> Something to consider... I don't think heart rate monitors go to sleep on their own. At least, I think mine stays on until it times out due to lack...

I think moving these pins is something we should target in the new pcb. I propose adding another section to the platformIO.ini for pcb2 and then compiler if statements in...

> Conditional compile is a good idea. > > Hibernation has also benefits for "old" boards only wake up is not working and you have to re power the board,...

Looks good! @MarkusSchneider , do you think we should still move the shifter pins to an RTC pin in PCB version 2.0? One of my concerns is the shifters are...

> I've added light sleep mode. In light sleep any gpio is able to wake up 😉. > > BLE, ERG and HTTP is stopped while sleep mode is enabled....

> Ok thx for point this out, I'll add the update of the timestamp also to the BLE-Server. > > Yes, leaving JTAG Pins free will allow to use a...

@MarkusSchneider , I'm just going through old issues and wonder if this is one we can tidy up and merge into develop?