bombsquad85

> > I've updated your macro and now it works... > > ``` > > [gcode_macro _exit_point] > > gcode: > > {% set function = 'pre_' ~ params.FUNCTION %}...

> you can only attach the probe after doing a G28 X and Y, so not sure on whats the issue here. If you are using klicky as a virtual...

I am also getting this message when I flash the latest kernel 

> > I downloaded the latest kernel but I get this error. > > Also do you need a specific mouse/keyboard? I'm new to this. The mouse I'm using (wired...

> one more test you can do, read the raw data at different position directly by M102 S-7, that can help to understand how it works > >  Hey...

> yes, you still can adjust the z_offset as before. is there a link to this?

> one of the reason is the homing speed is too slow, you can increase up the homing speed a little. so i had to slow down the homing speed...

just wanted to update this, i recalibrated the sensor while the printer was hot and so far so good, i am running some more tests to make sure that everything...

> need to run > > ``` > ~/Bed_Distance_sensor/klipper/install_BDsensor.sh > cd ~/klipper/ > ./make_with_bdsensor.sh > ``` > > to compile the firmware and then flash into the mcu again. here...

> Cleaned out ShakeNTune - but still getting same error but versions now clean > > > MCU Protocol error > > This is frequently caused by running an older...