Bed_Distance_sensor icon indicating copy to clipboard operation
Bed_Distance_sensor copied to clipboard
verified publisher icon markniu

not really an issue, but a question

Open bombsquad85 opened this issue 1 year ago • 3 comments

So I have been running my BD sensor in contact basically since install. i really like the autoz feature. i was just wondering is there a way to set it so that the z offset is slightly higher? i am finding that there is a little too much squish on my first layer and i have to babystep the z up.

Thanks in advance.

bombsquad85 avatar Oct 28 '24 15:10 bombsquad85

yes, you still can adjust the z_offset as before.

markniu avatar Oct 29 '24 01:10 markniu

yes, you still can adjust the z_offset as before.

is there a link to this?

bombsquad85 avatar Oct 29 '24 01:10 bombsquad85

like this: https://www.reddit.com/r/klippers/comments/oh0s50/how_to_save_z_adjust_after_tuning_during_print/ you can run SAVE_CONFIG to save the z offset after babystep

markniu avatar Oct 29 '24 01:10 markniu