RadianM

I've been trying to follow Russell's directions above but it hasn't quite worked out. >Goto the "File Storage" section for the camera and enable "Run A Command". Then set the...

Versions: > motionEye Version 0.39.3 > Motion Version 4.1.1 > OS Version Raspbian 9.4 OK, like you suggested, I put in some debug and I now realise I misunderstood the...

If polling for dashboard status updates is rate-limited to the imposed maximum of 150 calls/day, that doesn't seem to leave sufficient 'bandwidth' for actual commands? I want to use automations...

> each command you send is a call that goes on top of the polling commands In which case it would definitely appear that we need a way of setting...

> I noticed that problem as well. I "fixed" it by increasing the polling time to 90 seconds inside the current code. I think the value is definined in _init_....

IMO It's all a bit of an unpleasant mess now. I suspect the choice of rate limiting to 50/day has been set by them to cover half-hourly dynamic energy pricing....

> Depending of the availability of the S21 port, I think you can use both? Possibly, - I know there's a modbus adaptor available for most indoor units and I...

@mousetwentytwo I tried your FlowsetHcMax setting idea. Got some odd results. Earlier in the day I _had_ been trying to range rate the boiler using PartloadHCKW but as mentioned in...