RRP-support

Hi JelleB Thanks for the feedback. We are aware this is an issue, and are working to get the firmware compiling again under Arduino IDE. The main problem has been...

Thanks David. I think Adrian has worked out a way around the 'G' in names problem, though we haven't test it yet: commit 0.79 https://github.com/reprappro/RepRapFirmware/commit/3e3dda9d21b96ed10732a6c349579b7b0462bdf9 Perhaps extending this to only...

Hi Jason, This is something we intend to do. It won't be very quick, I'm afraid, as there are other firmware items that we have to address first. But you...

The current gcode axis homing commands in SD-Image/sys/ have a G92 [axis]0 command after the relevant move. The Y axis on Ormerod v1 is a special case; the axis has...

Thanks for the report, we'll look into it.

In 1.04, the first hot end is assigned T0, rather than T1. Not an issue for new users, as all our settings and gcode that is supplied have also been...

Hi mansj I can't think of anything that would specifically stop it working, but I don't have Simplyfy 3D available to test. Check in Pronterface or the web interface that...

This is an automated reply to your message "Re: [reprappro/RepRapFirmware] Add cold extrusion prevention plus override (M302) (#18)" sent to [email protected]. Dear Scott Lahteine [email protected] This is an automated reply...

Hi hieronymousch How are you generating gcode? Slic3r, Cura or some other gcode editor? Or through Repetier Host? To get the layer statistics working, the web interface has to find...

Hi hieronymousch I have replied by email, but I think the problem is you are using 'Lift Z'; ie between each move, the Z moves up, moves in X and...