RRP-support

Finer control for using microswitch endstops with IR sensor

1

Give finer control over specifying which axes use a sensor. Something like: M558 P1 X0 Y0 Z1 Where P0 is sensor off and P1/2/XXX is used for probe type (already...

While waiting for the temperature to reach the target temperature, no temps are sent via USB. I think that the web interface does report them during this time.

G32 should report bed compensation

1

Three points: 1. G32 should clear any compensation before applying new compensation. I think it adds to any already applied compensation? What's the point of having it add to the...

M206 just defines a move, then sets the co-ordinates it has moved from as the current location. The offset is lost as soon as you home the axes again. It...