Panayiotis-git


I cannot understand why the instructions tell to place the nut in the round hole. If you follow the instructions then the bolt protrudes on the upper side. The most...

> There's a recommendation I'd like to make, maybe let the part fan facing up instead facing down will help? Absolutely. It is awkward to let the fan blades hang...

Perhaps increasing the perimeters at this area would help.

It looks like your X axis is very tight or the extruder cannot move smoothly. If I understand it correctly, the printer detects a crash. It tries to re-home and...

Try to drill a small hole at the opposite side. Then insert a small metal pin and push it out.

create a new dirty.h file (next to the main.h) with content: #define FW_LOCAL_CHANGES 0

I remember some time ago, when I did some prints with many color changes per layer (over 10), the only reliable way to do the filament change was to use...

@3d-gussner, big thanks for your review! I've integrated the patch with your changes and fixes. After a bit of tweaking, the PR now only needs 62 bytes of ROM. Hey...

In order to mitigate the first drawback mentioned at the opening post, the M600, when issued, initializes the status message to the MSG_FILAMENTCHANGE.