bladeRF
bladeRF copied to clipboard
Nuand
bladeRF USB 3.0 Superspeed Software Defined Radio Source Code
I'm trying to run the bladeRF-fsk, and I'm getting the following error: Failed to set TX VGA1 gain: Operation not supported Looks like a cool demo. I'm guessing bladeRF-fsk may...
Hi! I'm trying to build my own gsm base station on Ubuntu 18.04 with bladeRFx40. After installations of YateBTS and BladeRF; I configured Radio.Band, Radio.C0, Identity.MCC, Identity.MNC, Identity.LAC on YateBTS....
Hi, I'm trying to make a mixer by subtracting the transmitted signal from the received signal to analyze the changes in the frequency which has occurred. but the subtract block...
When receiving samples through ``bladerf_sync_rx`` with two RX streams enabled (``BLADERF_RX_X2``), the timestamp increment in the returned meta headers of the blocks is always one higher than it should be....
I got compilation error on Fedora 36 with pybombs, so it turned out that there is a bug in this code. `termios_backup` is a pointer so we should not use...
Hi, I'm still learning to use BladeRF xA9 with GNU Radio Companion and wanted to modulate a signal and send it through a RF Cable and receive it on the...
Hello I try to test BladeRF under Pothos (built from source) and I get strange errors when using the bladerf soapy sink [22:22:54.214000] SoapySDR: bladerf_open_with_devinfo() [22:22:54.394000] SoapySDR: bladerf_get_serial() = 1d62a870f59e65fdd231ced37787b03a...
Hi, I've started working with the BladeRF xA9. Initially, I managed to transmit a signal and receive it when it gets reflected from a stationary target. I was wondering if...
Hi everyone, I am having problems when I receive signals using two SDRs (BladeRF - x40), one to transmit and one to receive (I know I can transmit and receive...
Hi, I'm working on BladeRF xA9 and trying to send and receive a signal using an antenna. I am sending the signal from one BladeRF on a metal foil and...