bladeRF
bladeRF copied to clipboard
Nuand
bladeRF USB 3.0 Superspeed Software Defined Radio Source Code
hello! i have a bladerf x40 that seems to boot fpga(3 leds at bottom lit green), but all communication to the fpga fails between the fx3 and the fpga with...
If no device is attached and I run ``` bladeRF-cli -e "" No bladeRF device(s) available. If one is attached, ensure it is not in use by another program and...
I have tried read and write IQ samples real time with bladeRF following the [instruction](https://github.com/Nuand/bladeRF/wiki/bladeRF-CLI-Tips-and-Tricks#Receiving_samples) Then I have connected baldeRF TX to [ublox ](https://www.u-blox.com/sites/default/files/ZED-F9P_InterfaceDescription_%28UBX-18010854%29.pdf) RX receiver but receiver couldnt estimate...
I have the xA5 BladeRF and I can't seem to flash the bitstream onto the board. On an Ubuntu system, I grab the bitstream from the Nuand website (https://www.nuand.com/fpga/hostedxA5-latest.rbf) and...
The online help file for bladeRF-cli contains the following line: "The n, samples, buffers, and xfers parameters support the suffixes K, M, and G, which are multiples of 1024." This...
I am dealing with the wideband signals on Bladerf. The U-shaped noise floor (which is caused by the Sigma Delta ADC) distorts my signal. On the other hand, I tried...
this happens when building current master with cmake 3.21.4: ``` CMake Warning (dev) at host/libraries/libbladeRF/CMakeLists.txt:428 (add_library): Policy CMP0115 is not set: Source file extensions must be explicit. Run "cmake --help-policy...
``` CMake Deprecation Warning at CMakeLists.txt:1 (cmake_minimum_required): Compatibility with CMake < 2.8.12 will be removed from a future version of CMake. Update the VERSION argument value or use a ......
Hi there, I installed gnuradio3.7.13.4 from source by following the process described from https://github.com/Nuand/bladeRF/wiki/Getting-Started:-Linux. The librairies used were extracted from https://wiki.gnuradio.org/index.php/UbuntuInstall. (Bionic Beaver (18.04) with gnuradio 3.7) my system :...
Hi! I have a trouble with bladeRFx40 and YateBTS on Ubuntu 18.04. Yate works normally for a while but it stops working after a few minutes. Versions info is shown...
