May0048


Dear @jjonkman I set static yaw angle within the ElastoDyn input，and YCMode is turned off at ServoDyn. The calculation starts still bouncing back to 0 degrees. Best regards,

My ElastoDyn and ServoDyn file Settings are as follows  

Dear @jjonkman (1) When using turbulent wind in FAST.Farm, high-resolution and low-resolution grids need to be generated separately with TurbSim? (2) If the above is true, which InflowFiles should each...

Hello, have you solved this problem yet? I encountered the same problem, but the above method did not solve it.

> I have this problem too, but I have eight fans. I had a problem with the eighth one, I removed the eighth one and it worked fine, maybe it...

> Dear @May0048, > > You are receiving this error because your low-resolution domain in FAST.Farm extends from -268 to 262 m in the Y direction while your TurbSim domain...

> Dear @May0048, > > Can you clarify what issue you are running into (plots would help)? The `WkPosδTαDγ` outputs will be zero until the wake reaches that downstream distance;...