JNP

> > In my opinion, it is an "LDO Leviathan" that was developed for "VORON DESIGN", so I would keep the name as it is. But I also sent JNP...

> > Scratch that. It's just _very_ picky apparently. > > Floating PA10 (UART1 RX) might confuse bootloader and cause "serial" DFU mode instead of "USB" mode. Can be fixed...

> > LDO Leviathan is correct because LDO is the manufacturer of this board and the sources are also on the LDO GitHub server. > > Thanks for confirming, @JNP-1!...

> > No STM32 I have worked with so far has had a problem. Also other boards have no pullup resistor. > > Personally run into this issue with F401CC...

The current is limited to 3A by the DCDC converter. However, I have also successfully tested the RPi5 and it works exactly the same way. I had not received an...

PG10 is a switched GND. PF10 is a 5V output (Neopixel). All fan outputs have a switched GND.

I looked at both data sheets and could not see any difference in the tach pin. Even if you connect the tach pin to GND, the fan must work. On...

The tach output of a fan is an open collector output. This means that the level depends on the signal from the pull-up resistor (to which voltage it is connected)...

The MCU only needs a 3.3V signal to recognize the tacho. So I don't understand why it shouldn't work with a 5V fan.

HDMI output is not stable, gives weird resolution of 900x1044 (tested with an Eizo monitor) DSI interface is not supported Overlays for different display missing