GregValiant

Thanks for the report. The center section of the menubar is missing in your screenshots. 5.8 is 7 versions out of date now. Cura 5.11 has been released. I suggest...

Thanks for the report. If you are going to try to print this without supports you need to enable the bridge settings. That will change the behavior. If there were...

I read your report. The settings you are using don't work together as you have found out. That model would typically be printed with support. You have chosen not to...

Thanks for the report. I haven't seen this problem. Someone from the Cura team will take a look. From the posted log file: 2024-10-13 12:48:59,496 - DEBUG - [MainThread] UM.TaskManagement.HttpRequestManager._onRequestError...

The Cura team prioritizes their workload and gets to things as they can on the basis of those priorities. If a problem can be re-created it can be addressed and...

Thanks for the report. I've been doing triage here for a few years now and out of all the models I've investigated - the original "Crystal Dragon" was the worst...

This is certainly "non-trivial" and would require a re-write of much of Cura's code. Path planning is a big part of what Cura does. The features are grouped together because...

Thanks for the report. I cannot duplicate the problem with UltiMaker Cura 5.8.0. I can duplicate the issue with the Elegoo fork of Cura. Your project file does not have...

Thanks for the report. Not all infill patterns fill a model at 100% density. For example "Lightning" infill can be printed to 240% before the line width gets to 0.40mm,...

You can add an override to your printer definition file and it will prevent this from happening again. The AnyCubic Kobra 2 printer definition file is in the Cura installation...