Jose M. Escrich
Jose M. Escrich
Dear all, i made all modifications sent to me ,but at end i still have same error: exit status 1 'HMC5883L' does not name a type Any suggestion about to...
Sorry but it’s not being so easy, of course I use Cube, and I did everything related to libraries as you said. First of all as far as I have...
What about to raise the range to 30A?, the first step is to change the shunt by a 0,01 Ohm one, why not create a calibration line of for example...
Documentation out dated, Marlin should be #define POWER_LOSS_PULLUP or #define POWER_LOSS_PULLDOWN ?
Data in the manual doesn't work
Documentation out dated, Marlin should be #define POWER_LOSS_PULLUP or #define POWER_LOSS_PULLDOWN ?
 This is the right way, isn't so complicated to decide Pull Up or Pull Down, you only need two tries, but any way, being right, doesn't work
Documentation out dated, Marlin should be #define POWER_LOSS_PULLUP or #define POWER_LOSS_PULLDOWN ?
 I think that everything could work, my feelings are that the sum of Power supply and UPS, are not enough to complete the power down cicle, Raise 10 millimeters...
> Oh, my mistake. About pouring printer it was a bad connection. > Now it's working. > But one of the relays is not flashing or something similar. > Doing...
The black supply module is intended to work between 100 and 250 vac, mains input voltage is not your problem
how do you make the short circuit detection?
There's no way to make the chip explode just closing the jumper, maybe you're doing something wrong, I have a couple of relays, and I don't use them, for some...