Jose M. Escrich

HMC5883L.h under STM32 problems on microprocessor

6

Dear all as I'm trying to use your good work to connect an HMC5883 accelerometer under an STM32F41XXX, I'm getting the error: compilation terminated. exit status 1 stm32f10x.h: No such...

help needed, to make work accelerometer on SPI3

1

Dear all, this is my Klipper, printer.cfg configuration for my Octopus v1.1 referring input shaping: [adxl345] cs_pin: PA15 spi_bus: spi3 [resonance_tester] accel_chip: adxl345 probe_points: 110,110,100 And everytime I try to...

Documented schemes for everyone; and a tough about an error from my side, connector 3 is not an Input, but an Output

4

Dear all, Finally, after some mistakes, and trials, this is my contribution to schemes and connections, connector marked as 3, is NOT an Input, connector number 3 is an OUTPUT,...

By some reason, doesn't matter how you install it, last time it was installed from KIAUH, Octoprint don't work, but their processes are still working  

I don't know if does it exists any way to make HDMI work, because you can attach an HDMI monitor, and you could see some light changes, but never a...

Problems if try to print a file, just after print the previous one

10

Dear all, first of all congratulations by create Pronterface, I'm using it from years ago, and I love it. This time I have an old issue, happening at least on...

 The symbol PWR-DET has been wrongly used at PROBE input.

Independent fan control

2

Dear all, I have one of my BTT Pi inside a Klipper machine, working with the code you provided to make the fan run, without any problem, but, I have...

Feature request; No way to remotely change filament

6

Dear all, I'm starting to use Prusa Link and Prusa connect, but I'm used to control all my other printers form my desktop computer, in the case of my Prusa,...

I'm worried because there is no way to send Gcode commands to printer, form Prusa Link, or Prusa connect web interface, in the same way as we can do using...