DaStivi

view-angle & fit button

5

hi, would it be possible to add the predefined view-angle and fit view button?

No Print Features Detected even if Verbose is enabled in Superslicer

10

Even if STL is sliced with verbose gcode enabled in Superslicer octolapse does not find the gcode... i've also tested with "Label object" on and off (option is for M486...

ABL mesh (on super res) does not test far end of the bed

4

Hi, ABL leveling starts the test really far in the front of the bed... Befor the leveling screws. But in the back it stops way before the back end, I...

[Bug] after some time past ah reboot jdownloader app crashes constantly

7

### Current Behavior after some time past ah reboot jdownloader app crashes constantly container log only shows following: [supervisor ] service 'app' exited (with status 0). [supervisor ] restarting service...

with superslicer sliced gcode crashes klipper - klippy shutdown

4

### What happened? for some, yet unknown reason to me, every print i sliced with superslicer crashes my voron 350 with klipper... not sure if i changed some version, as...

I've no [probe] section Defined as I use mentals/annex dockable probe. `################################################################### # Probe ##################################################################### #[probe] #pin: ~!PB7 #x_offset: 0 #y_offset: 25.0 #z_offset: 2 #speed: 20.0 #samples: 3 #samples_result: median...

Hi, did i just not see ah list of correct/allowed components parameters? Like "Azure AD" in Readme Supported Components section is AzureAD for Powershell!?! Steve