ABL mesh (on super res) does not test far end of the bed

[DaStivi]

Hi,

ABL leveling starts the test really far in the front of the bed... Befor the leveling screws.

But in the back it stops way before the back end, I would say either one more row would be possible or the testing grid should be slightly shifted backwards

[DaStivi]

This is the farest back "line" it's testing...

[thisiskeithb]

Further back & the nozzle will hit the bed connector/cable when probing that rear-left corner.

[DaStivi]

Further back & the nozzle will hit the bed connector/cable when probing that rear-left corner.

no really... only on the newer machines with the cable support strap.. and its even hitting this when using the UBL Firmware from luke allready...

[pixeldoc2000]

There is also the hardware limitation of the movement of the x-axes, as the Bed can't move much further back for the probe to reach the end.

With the BLTouch Mount from thingiverse right beforce the center Hotend Fan, the Probe is monted a little bit further back.