AbeFM
AbeFM
If the printer only works with your filaments, that's a "closed ecosystem". I do not feel it is consistent with the open source nature of the rest of the project.
You're right, that was not the response you deserved. The right response is: The problem is real, just because you don't often run across it personally doesn't invalidate my suggestion....
Bump. I still have to create 3 or 4 custom filaments for every print I do that involves multiple materials. I've seen this requested over and over on forums and...
I will try to reproduce this (and the minimum area bug from other thread) in the release versions and report back. Visiting family in town for a week, but I'll...
 First Click:  Printer is doing it again, E0 uses start code, E1 does not. I tried overwriting with " ;Trying to overwrite undesired startup code E1" and a...
I do now [BadTowersCleanCats.3mf.txt](https://github.com/smartavionics/Cura/files/3553017/BadTowersCleanCats.3mf.txt) I'm also irritated that `85% of the time I hit "slice", progress bad goes ~halfway, freezes, then blanks out. Hit cancel, then slice, and ~1/10th of...
With Prime Tower Brim off, but Brim on in general, I still get the error. With brim off..... I get.... A missing bottom layer. I'd say the issue is the...
Weak thick layers on prime tower is an issue that belongs on CuraEngine instead of here? Not quite ready to write it up yet
It's no show stopper for me personally, I just thought errors should be logged.
Ah, ok, thought you may have been familiar with the issue. Desired Behavior: For support floors and ceilings, use the "Minimum X/Y Distance", and use the "X/Y Distance" when "Z...