AbeFM

A little weirdness, as of yet unsure if it is related:  I believe it is using the wrong material for the very extreme layer of supports - perhaps the...

Different from the issue in previous post:  This is really working great! I'm getting my supports to hug my model, but not blemish. There's interface anywhere they are really...

This is just you posting the code I've been using to CURA proper? No further changes? Unrelated: Is there a "don't support bridges" equivalent? I have some designs with lots...

 I want to make my soluble interfaces larger so that the PLA can fit out of holes it is printed inside of. I'm not yet sure what's causing it,...

A couple more shots to illustrate behavior, varying floor thickness.  3mm roof, 1 mm floor  3mm roof, 3 mm floor Significant holes.  3mm roof, 7 mm floor...

Final point unless I find the difference - same file, closely related settings, this slices ok. Not sure the difference. [Hex1WorksOK-printed.3mf.txt](https://github.com/smartavionics/Cura/files/3536703/Hex1WorksOK-printed.3mf.txt) Is there a easy way to compare profiles?

Nevermind. That previous file doesn't work either if I make the roof and floor large. I sure is a lot of work to turn "don't print unsupported material" into code,...

 Clicking the "CODE" button, the first screen that comes up on the project, displays the readme. That front page is where I assume (right or wrong) the most important...

And the motors are always hot (was mistyped: good) , even just sitting there. Elsewhere I saw a complaint of the selector drum losing it's orientation but getting hot and...

My Prusa is now the loudest printer in the house. The "fan noise" on just the motors and drivers cooking. Thanks! -Abe. Sent from my "smart"phone, please excuse brevity and...