Михайло

Relay on ON by default.

2

I had a few moments when my printer was OFF and (for example at night) the electricity was shut down for a while. After it is recovered my printer is...

Is there any way to have both SD Card and USB Drive work together. If I enable `#define SDCARD_CONNECTION LCD` and `#define USB_FLASH_DRIVE_SUPPORT` I can only use USB Drive. when...

I have tried few carrier boards for rpi CM4, but no one can boot CB1 module. CM4 module works ok with that boards and both CM4 and CB1 works with...

Is there any guide on building marlin firmware for this board? I know there is no sd card to print from but i can attach btt tft display to the...

is there any way to integrate with VS Code? There is VS Code extension for brightscript language that allows to write code, compile and run the app, but with ukor...

Is it difficult to add ESP32-S3-WROOM N16R8 board support? 

### What happened and in what context? When I run `RESPOND PREFIX=tgalarm MSG="My message"` while the printer is printing something I see a small (~1 second) freeze of the printer's...